SashSense Developer Kit Student guide

Live USB readings

My kit is in pieces

Leave USB unplugged while you wire the boards.

Show me the wiring

My kit is assembled

Plug in the data cable and close Arduino Serial Monitor. Choose the kit’s port, which may say CP210x or USB-to-UART.

Waiting for the first reading
DistanceElapsed time (min:sec)

Latest readings

Disconnected
Distance
—mm
Sash opening
—cm
Temperature
—°C
Humidity
—%RH
Magnetic contactNot fitted

Close the sash first.

0 readings

Connection help and session storage

Use desktop Chrome or Edge. The first time you use a new board, upload the starter sketch with Arduino IDE. Close Serial Monitor and Serial Plotter. Connect a USB data cable, choose Connect kit and select the board’s serial port. If several ports appear, unplug the kit to see which port disappears, then reconnect it and choose that port. A sticker marked “Firmware loaded and checked” means the starter sketch is already installed.

The latest 3,600 readings stay in this tab. Export your CSV before closing or reloading the page. Reconnecting starts a new segment. CSV times use the laptop’s clock. Select “Switch fitted” if your kit uses a magnetic contact.

Open the student guide · Printable guide (PDF)